Jio F220B Dead After Flash Solution

Jio F220B Dead After Flash Solution [ Jio F220B Dead Recovery ]

Are you trying to repair the dead Jio F220B jeypad mobile? If yes, after the Flash Solution the Jio F220B is dead. We had already published an expansion article with the video "To Flash the Jio F220B without any error", so if you are going to flash the Jio F220b mobile using the Qflash Toolthane travel on the link.

But the problem is that some users have stopped their Jio F220B during the process. In fact, the reasons for different users may vary for example - this may be the wrong flash file or the brick of the wrong firmware flashing process.

So if you are one of those who are dead Jio F220B after the flash then follow the guide below and remove the dead Jio F220B easily. There is no need to go somewhere to repair your device. You can recover Jio F220B at your own home without any extra effort.

For this, we are connecting the direct download link of the Jio F220B Dead Recovery Flash file to the tool. Just download the Jio F220B dead retrieve flash file, tool, driver and then apply the following instructions as shown below.

The most common issue after flash

• Unable to give power to Jio F220B
• Jio F220B auto reboot
• Jio F220B stuck on jio logo
• Auto Restart

These are the most common issues about Jio F220B mobile after the flashing process. Do not worry, this is not a big deal and you can flash the device again without any errors.

Download Jio F220B Unbrick Flash File, Drivers and Tools

Download Jio F220b Dead Recovery Flash File Download

LYF Jio F220B Flash Tool  Download

Driver Download

Jio F220B dead after flash solution using Qflash tool

The Jio F220B is a Qulacomm chip-based keypad mobile, so we have to use any Qualcomm flash tool such as Miracle Tool, QFIL Tool or Qflash Tool etc.

At this time, we recommend that you flash the dead Jio F220B with the Qflash Tool, which is 100% working and tested by us.

• Download and remove all files [dead recovery flash files / drivers / tools] on the desktop.
• Install the Jio F220B Qualcomm driver on the PC. If already installed, skip the phase.
• Now open the extracted folder and install "QFLash Tool" on the PC. Here we are using the Qflash Tool Meta Build version 9.1.6.
• Now copy the "Jio F220b Dead Recovery Flash File" and move it to the "Qflash Tool" folder location.

Qflash Tool Folder Location Path: My Computer >> C Drive >> Qflash Tool

Please note: this step is important, otherwise the tool can show an error during the flashing process.

• Run "Qflash Tool" via desktop shortcut.
• Come on the device, remove the USB battery once and re-insert it.
• Press the Jio F200B boot press + USB cable

Jio F220B Boot: Press & hold * key + USB cable

• If the device is properly connected to the PC, it will show "Qualcomm HS-USB QDLoader 9008 Port" at the top of the tool as shown in the screenshot.

• Now click on the "Load Contents" button from the Flash File folder and load the "Content" file.

• Click the "Download content" button again to start the firmware flashing process.

• The Jio F220B Dead Recovery Flashing File Flashing Process will take approximately 5-10 minutes to flash the whole firmware.
• After the flash, remove the USB cable, remove the battery and re-insert and reboot the device.
• Done!!! The device will reboot without any problems.